Transform your unwanted 3D prints and household plastics into eco-friendly 3D printer filament! 🌱More Extrusion Info: https://www.DrDFlo.com/Extrusion.html ...
Holy crap, that’s a lot of work to get a roll of filament. That’s only economical if your time is worth nothing. Ugh.
Not to be like that… but… gases would be hard to print, I’m not sure why you’d want to….
Liquids could be interesting, for like, ice sculptures. But at that point you’d be having to extract heat from ambient… drop the build chamber below freezing
Eh. That could work, might be more complicated though.
I’m envisioning a freezer for an enclosure, then heat the water to just above melting. This would allow using essentially-fdm set ups on the printer itself.
Aren’t wind turbine blades fiberglass? Can fiberglass be printed?
Anything can be printed with enough heat.
See: lava
Post: “My hot end is only reaching earth’s mantle. Do I need to reach the surface of the sun to make this work?”
Now I want a Lava Printer
Not to be like that… but… gases would be hard to print, I’m not sure why you’d want to….
Liquids could be interesting, for like, ice sculptures. But at that point you’d be having to extract heat from ambient… drop the build chamber below freezing
Ice printing could work with supercooled water.
Eh. That could work, might be more complicated though.
I’m envisioning a freezer for an enclosure, then heat the water to just above melting. This would allow using essentially-fdm set ups on the printer itself.
Yes. Well they are mixed with an epoxy.
You can find the research online with all the details.
deleted by creator