So I set this text to change the bottom layer to concentric only for the text and I got this. I had this large flat area in my print and decided to spice it up a bit for fun without doing multicolor which would be 1, too annoying to do manually and 2, too visible for this part that needs to be all black. So here I have a nice DON’T PANIC on the back of it.

  • LazaroFilm@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    4
    ·
    2 months ago

    It really is t bad in the naked eye. I just slammed a reflection right on it. Or maybe was 0.01mm too high but I’ve seen way worse.

    • ExcessShiv@lemmy.dbzer0.com
      link
      fedilink
      English
      arrow-up
      2
      arrow-down
      7
      ·
      edit-2
      2 months ago

      People accept different qualities I guess, if you’re satisfied and it works then there’s no reason to change things. I would say there’s significantly more things that need tuning than just z offset.

        • ExcessShiv@lemmy.dbzer0.com
          link
          fedilink
          English
          arrow-up
          5
          ·
          edit-2
          2 months ago

          With a result like yours I’d honestly just start from the top of Ellis guide and follow through to the end, that should help you fix this and get a significantly better print quality. There’s likely a lot of things that are less than ideal, fixing only one or two won’t be enough.

        • fufu@feddit.org
          link
          fedilink
          English
          arrow-up
          4
          ·
          2 months ago

          Just jumping in here, the first layer does look kinda shitty, at least theres a lot of room for improvement.

          Here’s a little guide to improve on a multitude of things by teaching tech.

          Cool cura feature thou :)