So I set this text to change the bottom layer to concentric only for the text and I got this. I had this large flat area in my print and decided to spice it up a bit for fun without doing multicolor which would be 1, too annoying to do manually and 2, too visible for this part that needs to be all black. So here I have a nice DON’T PANIC on the back of it.

  • Joelk111@lemmy.world
    link
    fedilink
    English
    arrow-up
    24
    arrow-down
    1
    ·
    edit-2
    2 months ago

    It isn’t that bad. Just needs a bit of z-offset adjustment. Your comment isn’t helpful as it’s just an insult, not constructive criticism. Tell OP what they need to change to make their first layer not bad, don’t just tell them it sucks.

    • B0rax@feddit.org
      link
      fedilink
      English
      arrow-up
      3
      ·
      2 months ago

      PA is also way too low (if it is even set at all). It could reduce the „thickening“ of the lines at each end dramatically.

    • ExcessShiv@lemmy.dbzer0.com
      link
      fedilink
      English
      arrow-up
      4
      arrow-down
      3
      ·
      edit-2
      2 months ago

      Z offset like you mentioned is probably wrong, extrusion multiplier is probably wrong, extruder might be incorrectly calibrated, PA is definitely wrong. It really looks like it hasn’t received any tuning at all and this was just done with OTB defaults.