So every couple months I clean my resin contaminated alcohol using alum powder (link to a video about the process)

After cleaning it I let it sit in the settling containers until I need to clean my alcohol again. At which point I swap the alcohol that was cleaned into my main wash and cure station tub and then put the dirty alcohol into the other tub I use exclusively for cleaning the alcohol.

Edit: For those curious I can share an image of what the alcohol looks like after it’s had 24 hours to settle in the settling containers.

  • Gormadt@lemmy.blahaj.zoneOP
    link
    fedilink
    English
    arrow-up
    3
    ·
    11 months ago

    No idea unfortunately, I typically only print a few build plates of models a week and then it’s a few months between cleanings like this