Spidertron Spidertron does whatever a Spidertron doesNeeds only a little bit of supports you should be able to print the leg parts without supports with "engineered failure" cleaning up some of the small midair print spotsI connected the legs with an 6mm m3 screw threaded into the plasticThe long legs print vertically.I included an 8x sprew version.The hole in the center is for 1.75mm filament for increased strength.Added a smaller version that should print and assemble much easier. Doesn't require any extra hardware (other than glue)only needs supports only under the front of the legs the rest should be bridging