Does this hobby ever get easier or is it always like getting kicked in the nuts by Ronaldo?
Filament some how leaked up and burned on. I just don’t have it in me to keep tinkering. I just want to print
Does this hobby ever get easier or is it always like getting kicked in the nuts by Ronaldo?
Filament some how leaked up and burned on. I just don’t have it in me to keep tinkering. I just want to print
I’m guessing you have a nozzle not screwed in fully, or there was filament above the threads preventing it from seating. I’d warm the print head, remove the nozzle, run a bit of filament through without the nozzle, then yank it out, hopefully pulling any globs down and out of the heater block. Reassemble hot and make sure the nozzle seats firmly. Good luck!
Thank you!